Scale-Tec POINT Scale
Use these instructions to set up and connect a Scale-Tec POINT Scale to the FeedComp App.
⚠️ IMPORTANT: Visit the Scale-Tec Support Center for instructions on scale calibration, troubleshooting, and more. Contact Scale-Tec Support if you need more help with your scale.
Configure Scale Settings
Before you connect a Scale-Tec POINT scale to the FeedComp App, you must update the scale's display setting. If you skip this step, the scale may send invalid values to the app, which can cause incomplete feedings.
- Open the Scale-Tec POINT scale app.
- Select the scale device.
- Tap Configure Device.
- Tap Adjust Individual Settings.
- Under Display, tap C1: Display Count and set the value to 1.
- Tap Submit to save your changes.
Connect a Scale to the FeedComp App
🗒️ NOTE: Once you start an overnight loadovernight load, be aware that the equipment stays locked to the overnight load until it’s finished or cancelled. This means that you cannot use the same equipment to complete any other feedings until the overnight load is completed. If you connect to and attempt to feed using equipment containing an overnight load, an overnight load notification with a red alert icon 
displays.
If you started an overnight load by mistake, you can cancel or complete an overnight loadcancel it or drop the feed on the same day.
- Tap your user icon
at the top right of the screen.
- Tap
Settings.
- Select the Equipment to connect.
- Tap Connect to Scale and select the scale to connect. After a scale is connected to your mobile device, the Bluetooth icon
displays at the top left of each screen in the FeedComp App.
Loader View
See Set Up Loader View (BETA)Set Up Loader View (BETA) for setup details.